Programming instructions

Installation

2-11

Alvarion

Figure 2-4: The Waterproof Seal

Route a straight, uncrimped Ethernet cable (8-wire, 24 AWG)

through both the top nut and the waterproof seal.

4. Insert and crimp the RJ-45 connector. Refer to Appendix B for

instructions on preparing the RJ-45 cable connector.

5. Connect the Ethernet cable to the Outdoor unit RJ-45 connector.

6. Replace the waterproof seal and then the top nut. Make sure that the

external jack of the cable is well inside the waterproof seal to

guarantee a good seal.

7. Route the cable to the location selected for the Indoor unit.

Installing the Sun Cover (DS.5800D

Units Only)

With DS.5800D units, a plastic Sun Cover is provided to protect the

unit from direct sunlight. It is mounted to the front of the unit using

four standard screws (included).

NOTE:

The 8-wire cable should be shielded.