Programming instructions

2-10
BreezeNET DS.5800 System Manual
Manual Revision: 1.0
Figure 2-3: 3” Pole Mounting Installation Using the Supplied Brackets
Connecting the Ground and
Antenna Cables
The Ground terminal (marked ) is located on the bottom panel of the
outdoor unit. The Antenna RF connector (marked ) is located on the
top panel of the BU-DS.5800D outdoor unit.
1. Connect one end of the grounding cable to the Ground terminal and
connect the other end to a good ground connection.
2. For DS.5800D units, connect an RF cable between the antenna
connector and the antenna.
Connecting the Indoor-to-Outdoor
Cable
1. Remove the two screws holding the waterproof seal to the outdoor
unit and remove the waterproof seal.
2. Unscrew the top nut from the waterproof seal.
NOTE:
When inserting the open-ended screws, make sure to insert them with the grooves pointing
outwards; these grooves are intended to allow fastening of the screws with a screwdriver.