User`s guide

BreezeNET DS.11 Series User’s Guide
3-28
♦ Long Retry Limit: The maximum number of
transmission attempts for a frame that is longer than the
RTS Threshold. The default value is 4.
♦ Basic Rate: The maximum rate of multicast, broadcast
and control frames transmissions. Multicast and
broadcast transmissions are not acknowledged; therefore
there is a chance that such transmissions will not be
properly received without the possibility of using the
acknowledgement mechanism for retransmission.
Therefore, it is recommended to use a lower rate for
transmission of broadcast, multicast and control frames,
to increase the probability that they will be received
without errors. Enter the data rate at which broadcast,
multicast and control frames are transmitted. The
default value is 2 Mbps.
NOTE:
The Basic Rate parameter should be changed only if you are sure that all
units in the cell can handle the defined rate. Use this parameter with
caution, as it may bring the link down.
♦ Power: The transmit power level. The possible range is
from –4dBm to +24dBm.
NOTE:
The Power setting should not exceed the maximum output allowed in the
applicable regulatory domain according to Table 3-1 on page 3-22.