User`s guide

The DS.11 Configuration Utility
3-5
Unit Configuration Mode
The following sections describe the various screens, controls
and parameters available in Unit Configuration mode.
Control Window
In this section, you can:
♦ Discover the units that are connected to the network.
♦ View the DS.11 units that have been discovered by their
IP address.
♦ Select the units you wish to manage.
♦ Locate units behind a router that cannot be detected by
the autodiscovery feature
♦ Assign unit IP addresses based on unit MAC addresses.
♦ Set the SNMP Community string.
NOTE:
If there are many units in the managed network, you can enlarge the list
box by clicking the horizontal line above the list Click again to toggle back
the default display state. The list box also displays the location of each
unit, as set in the Station Status window.