User`s guide

BreezeNET DS.11 Series User’s Guide
2-16
Figure 2-4: The Waterproof Seal
3. Route a straight, uncrimped Ethernet cable (8-wire, 24
AWG) through both the top nut and the waterproof seal.
NOTE:
The 8-wire cable should be shielded.
4. Insert and crimp the RJ-45 connector. Refer to Appendix
B for instructions on preparing the RJ-45 cable
connector.
5. Connect the Ethernet cable to the Outdoor unit RJ-45
connector.
6. Replace the waterproof seal and then the top nut. Make
sure that the external jack of the cable is well inside the
waterproof seal to guarantee a good seal.
7. Route the cable to the location selected for the Indoor
unit.