User`s guide

Installation
2-13
Installing the Outdoor Unit
The outdoor unit can be secured to the pole using one of the
following options:
♦ Special brackets sets (supplied with each unit). There are
two pairs of threaded holes on the units, allowing the
use of the brackets with various pole widths.
♦ Metal bands (9/16” wide, minimum 12” long).
Figure 2-2 shows the locations of the holes and grooves on
the back of the unit.
Figure 2-3 illustrates the method of installing a unit on a
pole using the supplied brackets.
NOTE:
Make sure to install the unit with the bottom panel (the panel with the
signal strength bar and LEDs) facing downward.
Figure 2-2: Installation Holes/Grooves