User`s guide

BreezeNET DS.11 Series User’s Guide
2-4
Installation Overview
The following outlines the steps of the installation procedure.
1. Select appropriate locations for the outdoor unit, the
antenna (if using an external antenna) and the Indoor
unit.
2. Mount the outdoor unit. If using an external antenna
mount the antenna and connect it to the outdoor unit.
3. Connect a ground cable from the outdoor unit to an
appropriate grounding point.
4. Connect the Indoor-to-Outdoor cable to the outdoor unit
and route it to the location selected for the indoor unit.
Refer to Appendix B for instructions on preparing the
Indoor-to-Outdoor cable.
5. Mount the indoor unit. Connect the Indoor-to-Outdoor
cable to the indoor unit’s Radio port.
6. Connect the indoor unit’s Ethernet port to the user’s
network using an Ethernet cable.
7. Configure the unit’s parameters.
8. Align the antenna and verify connectivity with any other
units.
NOTE:
The indoor unit should only be connected to the power source after it has
been connected to the outdoor unit.