User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Arp Command (ARP Protocol)
Alvarion BreezeNET B130/B300 GigE 75 Operational User Manual
Enables to freeze ARP table. No more automatically updates allowed. The
command fixes only manual records and does not affect the radio interface with
active protocol MINT. Be careful when entering this command via telnet.
arp [-]proxyall [$ACL]
In proxyall mode the system will reply on all ARP requests, if respective IP target
address resides in the routing tables and reachable via interface other than
source MAC-address. I.e. if there is a route to the target IP then the system can be
considered as a gateway.
In proxyall mode, you can specify an $ACL list of addresses/networks which
limits replied ARP requests of the command with networks and addresses of the
$ACL list.
Example:
arp add 10.10.10.10 00:11:22:33:44:55
arp add 192.168.5.1 5544332211 proxy