User manual
Chapter 3 - Layer 2 Command Set - PHY and MAC MINT (“mint” command)
Alvarion BreezeNET B130/B300 GigE 48 Operational User Manual
procedures. The same key should be specified in the settings of the connecting
unit ("mint IFNAME -key").
lip. Local IP-address. This address will be assigned to this unit when the
connection with a remote is established
tip and mask. Target IP-address and mask. This address will be assigned to
the remote side when a connection is established. The mask is applied to both
Local IP and Target IP. If mask is not specified these addresses will not be used
lgw. Local gateway IP-address (will be assigned to the local node once
connection is established)
tgw. Target gateway IP-address (will be assigned to the remote node once
connection is established). None option forbids providing information about
default gateway (that is set by "addnode -defgw" command) to the remote node.
lcost. Local cost of the connection to this neighbor from current node. If not
specified, MINT will automatically calculate the cost
tcost. Target cost of the connection from this neighbor to the current node. If
not specified, MINT will automatically calculate the cost. If lcost and tcost
parameters are set on a pair of neighbors, lcost has a higher priority.
enable/disable/delete. Self-explanatory - enables, disables or deletes a
record in a local database.
maxrate. Target node maximum bitrate in kilobit per second.
setpri | addpri. This options allows setting/increasing the priority of packets
passing through to the specified node. "Setpri" parameter is used to change a
priority to the value specified in the command. When using "-1" value a
package priority is dropped to the lowest priority. "Addpri" is used to change a
priority only in case it is higher than the previous one (Note: the smaller is the
value the higher is the priority). So you can only increase priority using
"addpri" parameter.
note. This option allows making some word note (description) for the specified
node.
Example: