User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC MINT (“mint” command)
Alvarion BreezeNET B130/B300 GigE 47 Operational User Manual
3.2.2.7 Setting Signal Levels Thresholds
Syntax:
mint IFNAME [-loamp XX] [-hiamp XX]
 loamp. This option sets the minimal signal level for the neighbor. Signal level
is measured in dB above the noise threshold for the current bitrate. If the level
gets lower than specified value the connection with a neighbor will be lost.
Default value is 2. The possible range is 0 to 6.
 hiamp. This option sets the minimal SNR for a new neighbor. Signal level is
measured in dB above the noise threshold for the current bitrate. If neighbor's
signal level is equal or higher than a specified value the node will consider this
neighbor to be a candidate. Default value - 6
Example:
mint rf5.0 -loamp 2
3.2.2.8 Creating Local Nodes Database
Syntax:
mint IFNAME addnode -mac X:X:X:X:X:X [-key STRING] [-note
STRING]
[-maxrate XX]
[-lip X.X.X.X] [-tip X.X.X.X] [-mask
X.X.X.X]
[-lgw X.X.X.X] [-tgw {X.X.X.X | none}]
[-lcost XX] [-tcost XX] [{-setpri |
-addpri} NN | -1]
[-disable | -enable | -delete]
mint IFNAME addnode [-defgw X.X.X.X] [-defmask X.X.X.X]
This set of parameters defines the nodes with which a given node can work with.
The following parameters can be specified:
 mac. This parameter is mandatory. X:X:X:X:X:X is a MAC-address of the node
with which a connection can be established.
 key. Unique unit's key (key word or phrase up to 64 characters long; if
contains spaces should be put into quotes). Used in authentication