User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Rfconfig Command (Radio Interface Configuration)
Alvarion BreezeNET B130/B300 GigE 38 Operational User Manual
3.1 Rfconfig Command (Radio Interface
Configuration)
The command is used to configure a radio module.
Syntax:
rf interface parameters...
Interface rf5.0 parameters:
band XXX: bandwidth (MHz) - {double (40)|full (20)|half
(10)|quarter (5)}
freq XXX: central frequency
bitr XXX: bitrate (Kbps)
sid XXX: system identifier - up to 8 hex digits.
txpwr XXX: tx power (dBm)
[-]pwrctl : automatic TPC mode
[noise XXX]
where Commands:
rfconfig IFNAME capabilities
rfconfig IFNAME statistics
Options description:
Sets parameters of a radio module specified by the IFNAME (name of the radio
interface) parameter, or displays them if executed without any optional
parameter. Optional parameters are as follows:
 band XXX: this option allows choosing the channel width for transmitting.
Double means 40 MHz, Full - 20 MHz, half - 10 MHz, quarter - 5 MHz. Units
in one PTP connection must have the same channel width. Example:
rf rf5.0 band half