User manual

Chapter 4 - Layer 3 Command Set - IP Networking Netstat Command (Network Statistics)
Alvarion BreezeNET B130/B300 GigE 169 Operational User Manual
4.8 Netstat Command (Network Statistics)
Display the network statistics
Syntax:
netstat -r
netstat -i
Description:
Displays the contents of different system data pertained to network parameters.
"-r" parameter displays system routing tables:
Flags for specific routes have the following meaning:
 U - this routing table element is currently active;
 H - this route leads to a host. If this flag is not set, the route goes to a network;
 D - the route has been created using the icmp redirect protocol;
 M - the route has been modified using the icmp redirect protocol;
 G - the route is connected to a host. If this flag is not set, it is considered that
the route destination is directly connected;
 S - static route, set by the operator using a route add command;
 1 - pseudostatic route, set as a result of a rip static command;
 L - the route points to a directly connected host (for such a route an APR
request may be performed);
Figure 4-6: Netstat Output