User manual

Chapter 4 - Layer 3 Command Set - IP Networking Ifconfig Command (Interfaces Configuration)
Alvarion BreezeNET B130/B300 GigE 104 Operational User Manual
4.1 Ifconfig Command (Interfaces
Configuration)
The command is used to set and view configuration of network interfaces.
Syntax:
ifconfig IFNAME
[address[/netmask] [ [delete | -alias] [ up ] [ down ]
[mtu N]
[media MediaType]]
[vlan TAG [-]vlandev IFParent]
ifconfig -a
Media type:
1000BaseFX-fullduplex, 1000BaseFX-halfduplex,
1000BaseTX-fullduplex, 1000BaseTX-halfduplex,
100BaseTX-fullduplex, 100BaseTX-halfduplex,
10BaseT-fullduplex, 10BaseT-halfduplex,
auto
Description:
This command allows setting and viewing the configuration of interfaces specified
by their ID numbers.
The command has the following parameters and flags:
 IFNAME: specifies the name of an interface (to see all interface names, an
ifconfig -a or netstat -i command may be executed).
 address: specifies the IP-address assigned to the interface. May be specified
as:
» address/number of bits in the mask
» address:mask
» address proper