Specifications

Chapter 3 - Commissioning Configuring Basic Parameters
BreezeNET B 39 System Manual
NOTE 1 (FCC 5.3 GHZ, 20 MHz Bandwidth):
For full compliance with FCC regulations, the following requirements should be
followed in units using a 20 MHz bandwidth:
1 In units HW Revision B, if you wish to include frequency channel 5270 MHz in
the set of frequencies to be used, then the Transmit Power parameter in the
BU, and the Maximum Tx Power parameter in the RB, should not be set to a
value above "17-Antenna Gain". If there is a need to use a higher value for
these parameters, this frequency should not be used.
2 In units with HW Revision C, if you wish to include one or more of frequency
channels 5270, 5275 and 5330 MHz in the set of frequencies to be used, then
the Transmit Power parameter in the BU, and the Maximum Tx Power
parameter in the RB, should not be set to a value above "20-Antenna Gain". If
there is a need to use a higher value for these parameters, this frequency
should not be used.
Table 3-2: Regulation Maximum EIRP
Country Code Maximum EIRP (dBm)
FCC 5.3 GHz 30 for 20 and 40 MHz bandwidth,
27 for 10 MHz bandwidth
(NOTES 1, 2, 3)
FCC 5.4 GHz 30 for 20 and 40 MHz bandwidth,
27 for 10 MHz bandwidth
ETSI 5.4 GHz 30 for 20 and 40 MHz bandwidth,
27 for 10 MHz bandwidth
ETSI-F 5.4 GHz 30 for 20 and 40 MHz bandwidth,
27 for 10 MHz bandwidth
Australia 5.4 GHz 30 for 20 and 40 MHz bandwidth,
27 for 10 MHz bandwidth
Universal 5.4 GHz 49
UK 5.8 GHz 36 for 20 and 40 MHz bandwidth,
33 for 10 MHz bandwidth
Australia 5.8 GHz 36
India 5.8 GHz 36
Germany 5.8 GHz 36 for 20 and 40 MHz bandwidth,
33 for 10 MHz bandwidth
ETSI 2.4 GHz 20 for 20 and 40 MHz bandwidth,
17 for 10 MHz bandwidth