Specifications

Chapter 2 - Installation Installing the Universal IDU Indoor Unit
BreezeNET B 33 System Manual
5 Connect the 10/100 BaseT ETHERNET connector (located on the side panel of
the PS1073 IDU) to the network. The cable connection should be a straight
Ethernet if connecting the indoor unit to a hub/switch and a crossed cable if
connecting it directly to a PC Network Interface Card (NIC).
2.4.1 RESET Button Functionality
Using a sharp object, press the recessed RESET push button for a short time to
reset the unit and reboot from the Main version.
In units with ODU HW revision C or higher, the RESET button can be used for
setting the unit to its factory defaults. Press the button for at least 5 seconds
(until the ETH LED of the IDU stops blinking): the unit will reboot with the factory
default configuration.
NOTE
The length of the Ethernet cable connecting the indoor unit to the user's equipment, together with
the length of the Indoor-to-Outdoor cable, should not exceed 100 meters.