Specifications

Chapter 4 - Operation Menus and Parameters
BreezeNET B 176 System Manual
The measurement unit is 250 microseconds and the range is from 1 to 40 (0.25 to
10 milliseconds) or 0 to disable bursts for high priority packets.
The default is 20 (5 milliseconds).
4.2.6.6.3.6.8 RB Burst Duration for Low Priority Traffic
The RB Burst Duration for Low Priority Traffic parameter defines the maximum
duration of a burst that can be made by the RB for low priority packets.
The measurement unit is 250 microseconds and the range is from 1 to 40 (0.25 to
10 milliseconds) or 0 to disable bursts for low priority packets.
The default is 12 (3 milliseconds).
4.2.6.6.4 Show Service Parameters
Displays the current values of the Service Parameters.
4.2.6.7 Security Parameters
BreezeNET B can support encryption of authentication messages and/or data
frames using one of the following encryption standards:
 WEP Wired Equivalent Privacy algorithm. WEP is defined in the IEEE 802.11
Wireless LAN standard and is based on the RSA's RC4 encryption algorithm.
 AES OCB Advanced Encryption Standard. AES is defined by the National
Institute of Standards and Technology (NIST) and is based on Rijndael block
cipher. AES OCB (Offset Code Book) is a mode that operates by augmenting
the normal encryption process by incorporating an offset value.
 FIPS 197 is certified for compliance with Federal Information Processing
Standards. It provides encryption and message integrity in one solution and
implements the Advanced Encryption Standard using Rijndael block cipher.
The following parameters are available through the Security Parameters menu (in
certain units some or all of the security options may not be available):
 Authentication Algorithm
 Data Encryption Option
 Security Mode
 Default Key (RB only)