Specifications

Chapter 4 - Operation Menus and Parameters
BreezeNET B 165 System Manual
4.2.6.6.1.2 Set/Change Filter IP Address Range
The Set/Change Filter IP Address Ranges option enables defining/updating up to
8 IP address ranges to/from which IP frames are to pass if the User Defined
Addresses Only option is selected in the User Filtering Option parameter.
The default Filter IP Address Range is 0.0.0.0 TO 0.0.0.0 (all 8 ranges).
A range can be defined using a string that includes either a start and end address,
in the format "<start address> to <end address>" (example: 192.168.1.1 to
192.168.1.255), or a base address and a mask, in the format "<base address>
mask <mask>" (example: 192.168.1.1 mask 255.255.255.0).
4.2.6.6.1.3 Delete Filter IP Address Range
The Delete Filter IP Address Range option enables deleting IP address range
entries from the Filter IP Address Ranges list.
4.2.6.6.1.4 Delete All User Filtering Entries
The Delete All User Filtering Entries option enables deleting all entries from the
Filter IP Address Ranges list.
4.2.6.6.1.5 DHCP Unicast Override Filter
When user filtering is activated, unicast DHCP messages are filtered out; therefore
the unit cannot communicate with the DHCP server. The DHCP Unicast Override
Filter option enables to overcome this problem. When enabled, unicast DHCP
messages pass, overriding the user filtering mechanism.
The default is Disable DHCP Unicast.
4.2.6.6.1.6 Show User Filtering Parameters
The Show All User Filtering Parameters option displays the current value of the
User Filtering Option and the list of User Filtering addresses, subnet masks and
ranges.
4.2.6.6.2 MIR Parameters (RB only)
The Maximum Information Rate (MIR) value specifies the maximum data rate
available for burst transmissions, enabling to limit it to a value lower than the
maximum supported by the unit. The MIR values indicate the achievable net
throughput for FTP applications.
The MIR algorithm uses buffers to control the flow of data. To balance the
performance over time, a special Burst Duration algorithm is employed to enable
higher transmission rates after a period of inactivity. If no data is received from
the Ethernet port during the last N seconds, the unit is allowed to transmit N
times its allowed IR value without any delay. For example, if the Burst Duration is
set to 0.5 second (or more), then after a period of inactivity of 0.5 seconds up to
128 Kbits x 0.5 = 64 Kbits may be transmitted to a unit whose IR is 128 Kbps,