Specifications

Chapter 4 - Operation Menus and Parameters
BreezeNET B 139 System Manual
4.2.6.3.5 Delete All Network Management IP Addresses
The Delete All Network Management IP Addresses option enables deleting all
entries from the Network Management IP Addresses list.
4.2.6.3.6 Set/Change Network Management IP Address Ranges
The Set/Change Network Management IP address Ranges menu enables defining,
updating or deleting IP address ranges from which the unit can be managed if the
Network Management Filtering option is enabled. This is in addition to the
previous options in the Network Management menu that enable defining,
updating and deleting discrete IP addresses.
The menu includes the following options:
4.2.6.3.6.1 Set/Change Network Management IP Address Ranges
The Set/Change Network Management IP Address Ranges option enables
defining/updating up to 10 IP address ranges from which the unit can be
managed if the Network Management Filtering option is enabled.
The default Network Management IP Address Range is 0.0.0.0 TO 0.0.0.0 (all 10
ranges).
A range can be defined using a string that includes either a start and end address,
in the format "<start address> to <end address>" (example: 192.168.1.1 to
192.168.1.255), or a base address and a mask, in the format "<base address>
mask <mask>" (example: 192.168.1.1 mask 255.255.255.0).
4.2.6.3.6.2 Delete Network Management IP Address Range
The Delete Network Management IP Address Range option enables deleting IP
address range entries from the Network Management IP Address Ranges list.
4.2.6.3.6.3 Delete All Network Management IP Address Ranges
The Delete All Network Management IP Address Ranges option enables deleting all
entries from the Network Management IP Address Ranges list.
4.2.6.3.7 SNMP Traps (BU Only)
The SNMP submenu enables or disables the transmission of SNMP Traps. If this
option is enabled, up to 10 IP addresses of stations to which SNMP traps are sent
can be defined.
Starting on SW Version 5.0, traps are generated and sent only by the BU: relevant
events in an RB are reported by the RB to the serving BU that generates the
applicable trap on behalf of the RB.
For more details on the system traps see the relevant Traps document.