Specifications

Chapter 4 - Operation Menus and Parameters
BreezeNET B 132 System Manual
4.2.6.2.18.1 Basic Settings
The Basic Settings menu is used for collecting the primary input required for the
analysis process.
4.2.6.2.18.1.1Installation Model
This setting defines the topography:
 0 - LOS: Units have clear line of sight between them
 1 - Near LOS: Units have minor obstacles in their path, which are easily
avoidable through multipath
 2 - Non LOS: Units are obstructed and the signal must travel through longer
paths or less permissive media
The default is Near LOS.
4.2.6.2.18.1.2Minimum Desired Performance
This setting defines the minimum throughput that must be ensured when
optimizing the achievable distance. Not applicable when the Optimize
Performance for Minimum Desired Distance optimization criterion is used.
The available range is from 500 to 6000 (kbps).
The default is 3000 (kbps).
NOTE
When performing calculations, the Interference Mitigation mechanism also takes into consideration
the following parameters which are set in their specific menus:
 Antenna Gain [see “Antenna Gain” on page 120]
 Country Code [see “Country Code Parameters” on page 179] as it affects EIRP and
Maximum TX Power limits
 TX Power (BU) [see “Transmit Power” on page 116) and Maximum TX Power (RB) [see
“Maximum Transmit Power (RB only)” on page 117)
 Sub-band [see “Sub Band Select” on page 110) as channel bandwidth affects Noise Floor
which in turn affects maximum distance
Make sure those parameters are properly configured before activating Interference Mitigation. It is
recommended to re-run Interference Mitigation after changing any of the above.