Instruction manual

4-2
BreezeACCESS Version 4.3 Commissioning
Manual Revision: 4.0
Verifying Connectivity
Verifying the Ethernet Connection
Once you have connected the unit to an Ethernet outlet, verify that the
Ethernet Integrity indicator (the yellow LED embedded in the Ethernet
connector) is on, indicating that the unit is connected to an Ethernet
segment. The Ethernet Activity indicator (the green embedded LED)
should blink whenever the unit receives or transmits traffic on the
Ethernet port.
Verifying Data Connectivity
(Subscriber Unit)
From a user’s PC or from a portable PC connected to the unit, ping the
Access Unit or try to connect to the Internet.
Verifying Telephone Connectivity
(Subscriber Units with Voice
support)
To verify correct operation of the telephone, a test telephone with the
default telephony parameters and a known IP address should be
connected to the system (the location of the test telephone is determined
by the system administrator).
Perform the following steps to verify telephone connectivity:
1. Use IP dialing to call the test telephone: dial * followed by the 12-digit IP
address of the test telephone. Verify connectivity. During the conversation,
verify that the other party has your IP address.
2. After terminating the call, the other party should use the test telephone to
call your IP address and verify that the telephone, including the ringing
circuits, functions properly.