Instruction manual

1-6
BreezeACCESS Version 4.3 Commissioning
Manual Revision: 4.0
Once the basic parameters are configured, the unit must be reset in
order to activate the new configuration.
Hopping Sync
(AU-BS only)
Idle 1. Cannot be changed in
BreezeACCESS 5.7 GHz units
configured to Hopping Band
ISM US FCC.
2. If synchronization without
GPS is to be supported, one AU
should be configured to Master,
all other AUs should be
configured to Slave.
3. When GPS is used for
synchronization, all AUs should
be configured to Slave.
Transmit Power Control 7
ATPC Option AU: Disable
SU: Enable
Receive Attenuation Control
(SU)
0
Scanning Mode (SU) Active
ESSID ESSID1
Operator ESSID Option (AU) Enable
Operator ESSID (AU) ESSID1
Best AU Support (SU) Disable
Preferred AU MAC Address
(SU)
00-00-00-00-00-00 (none) Applicable only when Best AU
Support is enabled
VLAN Link Type Hybrid Link
VLAN ID – Management 65535
Authentication Algorithm Open System In the SU, can be changed to
Shared Key only after
configuring the WEP Key and
the applicable Default Key ID. In
the AU at least one WEP key
must be configured.
Default Key ID (SU) 1
WEP Key 1-4 0000000000 (none)
Parameter Default Value Comment