Instruction manual

IF Based Equipment
1-21
BreezeACCESS Version 4.3 System Manual
Table 1-10: BS-GU Connectors
Table 1-11: BS-GU LEDs and Switches
Connector Name Functionality
SYNC IN Receives signals from the GPS antenna unit.
If more than one collocated BS-GU module is daisy-chained, this
connector is used by a “Slave” module to receive signals from the
“Master” module’s SYNC OUT connector.
SYNC OUT Transfers the signals received on the SYNC IN port.
If the module is a “Master” operating in “local” mode, the internally
generated synchronization signals are also transferred to the “Slave”
via this connector.S
AL IN Four connections to receive indications from external devices.
AL OUT Three relay outputs to external devices.
ETH Ethernet 10BaseT interface. Use a straight cable to connect directly to
a PC. Use a crossed cable to connect to a hub.
LED Name Functionality
LED Name Functionality
PWR (green) On – Power supply functioning properly.
Off – Power supply not functioning properly.
OK (green) On – Proper signals are being received from the GPS antenna.
Off – The GPS antenna is not connected or it is not functioning
properly.
A1 (red) On – Alarm In 1 (external) is activated.
A2 (red) On – Alarm In 2 (external) is activated.
A3 (red) On – Alarm In 3 (external) is activated.
A4 (red) On – Alarm In 4 (external) is activated.
A5, A6 (red) Reserved for future use.
Ethernet Activity -Ethernet
Connector embedded LED
(green)
On – Receiving traffic on the Ethernet port.
Off – No activity on the Ethernet port.
Ethernet Integrity -Ethernet
Connector Embedded LED
(orange)
On – Unit is connected to an Ethernet segment.
Off – Unit is not connected to an Ethernet segment.
Reset Press this button with a paper clip or similar object in order to reset
the unit.