Instruction manual

IF Based Equipment
1-13
BreezeACCESS Version 4.3 System Manual
The SU-NI/AU-NI provides the following interfaces:
 An Ethernet connector (marked ETH) for connecting the unit to the
network. See Table 1-1‚ page 1-4
for information on the required
type of Ethernet cable.
 An IF connector for connecting the unit to an outdoor unit.
 A DC-12V connector for the power supply.
 A MON connector for connecting an ASCII terminal with terminal
emulation software for configuration and maintenance purposes.
 A TEL connector (Sunscriber Units with voice support only) for
connecting a regular telephone.
Installing the SU-NI/AU-NI Unit
1. Place the unit in an appropriate location on a shelf or a table. The unit can be
wall mounted using the installation materials provided with the unit. Use a 6
mm (1/4") drill and the supplied template plate for easy and accurate marking
of the holes.
2. Connect the power supply DC power cord to the DC In jack (marked
DC-12V) located on the rear panel of the unit
(shown in Figure 1-5‚ page 1-12
).
3. Connect the IF cable to the IF connector (marked IF). The other side of the
IF cable should already be connected to the outdoor unit.
4. Connect the mains power cord to the power supply unit. Connect the mains
power plug to a mains power outlet.
5. Verify that the Power LED (marked PWR) located on the front panel of the
unit, as shown in Figure 1-6‚ page 1-12
, is lit.
NOTE:
In order to avoid inadvertantly transmitting on incorrect frequencies, the basic
parameters of the unit should be configured before connecting the antenna.