Instruction manual

C-46
BreezeACCESS Version 4.3 System Manual
Manual Revision: 4.0
Traps
Trap (Number) Description Variables
*SUassociatedAUTRAP(2) An AU trap indicating a new association
with an SU.
*TrapSUMacAddr
*AUdisassociatedTRAP(3) An AU trap indicating that an SU has
been disassociated from the AU. The
AU decides that an SU has been
disassociated from it and remove it
from the ADB after receiving from
another AU a SNAP frame with the SU
MAC address. The SNAP frame
indicating a network topology change
where the SU has associated with
another AU will be received if both AUs
are connected to the same Ethernet
backbone.
*TrapSUMacAddr
*AUagingTRAP (4) An AU trap indicating that an SU was
aged out and removed from the ADB
following its failure to acknowledge a
certain number of consecutive frames
transmitted to it.
*TrapSUMacAddr
*SUassociatedTRAP (6) An SU trap indicating association with
an AU. In addition to the MAC address
information of the AU, the trap also
includes information on the average
RSSI of frames received from the AU.
*AssociatedAU
*LastAUMacAddress
*TrapRssiQuality
*TrapLastRssiQuality
*SUWirelessQualityTRAP(7) An SU trap, indicating that the quality of
the wireless link has changed and
dropped below (On) or has improved
above (Off), defined by the
*WirelessTrapThreshold.
The threshold is in RSSI units.
*TrapToggle
*UnitMacAddress
*TrapRssiQuality
*AUWirelessQualityTRAP(20) An AU trap, indicating that the quality of
the wireless link with a specific SU has
changed and dropped below (On) or
has improved above (Off) a threshold
defined by *WirelessTrapThreshold.
The threshold is a percents
(retransmissions as percentage of total
transmissions).
*TrapToggle
*TrapRTx
*PowerUpFromReset (101) A trap indicating power up after Reset. *UnitMacAddr
*AULossOfSyncTRAP (21) A BS-AU trap indicating that the AU has
lost (alarm on) or regained (alarm off)
synchronization. Applicable only to
units in which the Hopping Sync is
configured to slave operation.
*TrapToggle
*UnitMacAddress
*MonitorStatusTRAP (102) A trap indicating that a log-in or log-out
has been performed via the Monitor
port or Telnet. Includes the log-in
access right and the IP address of the
PC performing Telnet (if access is via
Monitor the address is 0)
*TrapLog
*TrapAccessRights
*TrapTelnetUserIpAddress
*ParameterChangedTRAP(103) An AU or SU trap indicating a change in
a CIR/MIR, IP Filter, Accounting
(billing) or VLAN parameter.
*TrapParameterChanged
*GpsAlarmInTRAP (104) A GU trap indicating a change in alarm-
in status
*brzaccTrapToggle
*AlarmName
*AlarmNumber
*GpsAlarmOutTRAP (105) A GU trap indicating a change in alarm-
out status
*brzaccTrapToggle
*AlarmName
*AlarmNumber
*GpsUTCstatusTRAP (106) A GU trap indicating a change in UTC
status. On status is when the GU
module receives UTC information from
the GPS antenna. This information is
useful only if the GU receives also PPS
signals from the GPS antenna,
indicated by an on status of Alarm In 5
(GPS Antenna Alarm).
*TrapToggle