Instruction manual

Menus and Parameters
2-99
BreezeACCESS Version 4.3 System Manual
assumed to be the destination IP address. 12- and 3-digit numbers
are allowed. 3- digit numbers are used to dial to stations in the
same subnet, and 12- digit number are used to dial to any IP
address. If a 3-digit number is dialed the Setup message is sent to
the corresponding IP address in the local subnet. When dialing a
12-digit number (e.g. abcdefghijkl), the Setup message is sent
directly to the IP address abc.def.ghi.jkl.
Valid values: up to 3 phone key-pad digits (0-9, *, #, A, B, C, D)
The default value is *.
 Automatic Prefix – specifies a default prefix (number of the
Gateway trunk port) to be automatically inserted and transmitted to
the gateway before the dialed number. The Automatic Prefix will be
inserted only if the Dialing Option parameter (see below) is
disabled, or if it is enabled and the first dialed digit is different from
the defined Inter-Regional Prefix.
Valid values: up to 8 phone key-pad digits (0-9, *, #, A, B, C, D)
The default is X (no Gateway Prefix).
 Fast Start – Enables or disables the fast connect protocol, which is
a H.323 Version II feature that allows decreasing the connection
set-up time (if supported by the Gateway).
The original procedure prior to H.323 Version II required four round
trips of messages between endpoints before the first media stream is
exchanged between peers. Fast Connect, or Fast Start, is a new
procedure added to H.323 version II. It reduces the number of
round trips to one by combining the call connect procedures into a
single H.225 transaction.
The default selection is Enable.
 Information Transfer Capability – To define the value of the
information transfer capability element in the Q.931 SETUP
message.
Available selections:
 Speech (used by H.323 speech terminals)
 Unrestricted (used by H.323 AudioVisual terminals for
unrestricted digital information)
 Restricted (used H.323 AudioVisual terminals for restricted
digital information)
 3.1 kHz audio (used by H.323 speech terminals)
 Unrestricted with tones (used by H.323 AudioVisual terminals
for transmission of unrestricted digital information with
tones/announcement)
 Video (not used by H.323 terminals)
The default is Speech.