Instruction manual

2-68
BreezeACCESS Version 4.3 Operations and Administration
Manual Revision: 4.0
Table 2-14: Per Trap Control
 SNMP Traps IP Destination – Displays the current values of 3
IP addresses that are defined as the trap destinations. Allows
entering a new address for each of the 3 entries.
 The default of all three SNMP Traps IP Destinations is
0.0.0.0.
 SNMP Traps Community – Defines a new community string for
each of the 3 SNMP Trap IP Destination entries.
 Valid strings: Up to 14 ASCII characters, case sensitive.
 The default for all 3 entries is public (read-only).
 Delete One Trap Address - Deletes one of the 3 IP address
entries from the list of SNMP Traps IP Destinations.
 Delete All Traps Addresses - Deletes all entries from the list of
SNMP Traps IP Destinations.
 Show SNMP Traps Parameters – Displays the current values of
the SNMP Traps parameters.
 Show Network Management Parameters – Displays the current
values of the Network Management parameters.
Trap Unit Default
Send SU Associated AU Trap AU Enable Trap Sending
Send Disassociated Trap AU Enable Trap Sending
Send AU Aging Trap AU Enable Trap Sending
Send AU Wireless Quality Trap AU Enable Trap Sending
Send SU Associated Trap SU Enable Trap Sending
Send SU Wireless Quality Trap SU Enable Trap Sending
Send Parameter Changed Trap AU, SU Enable Trap Sending
Send GPS Alarm In Trap GU Enable Trap Sending
Send GPS Alarm Out Trap GU Enable Trap Sending
Send UTC Status Trap GU Enable Trap Sending
Send Power Up From Reset Trap All AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Send Monitor Status Trap All Enable Trap Sending
Send Cold \ Warm Start Trap All AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Send AU Loss Of Sync Trap BS-AU in slave mode Enable Trap Sending
Send AU Alarms Traps IF-based AU Enable Traps Sending
(applicable to all AU Alarms
Traps)