Instruction manual

Menus and Parameters
2-67
BreezeACCESS Version 4.3 System Manual
entries in the Set Network Management IP Addresses list. If the
Access to Network Management parameter is configured to
From Both Ethernet & Wireless Link, then there is no
IP-address-based filtering on the Ethernet port.
 Activate Management IP Filter On Both Ethernet & Wlan
Ports – Applicable with all options of the Access to Network
Management parameter. The unit can be managed from the
port(s) defined by the selected option of the Access to Network
Management parameter only by stations whose IP addresses
match one of the entries in the Set Network Management IP
Addresses list.
The default selection is Disable.
 Set Network Management IP Addresses – Displays the IP
addresses of the stations that can manage the unit (if Network
Management Filtering option was enabled) and allows you to enter
new addresses; up to three IP addresses can be defined.
The default value is 0.0.0.0 for all 3 addresses.
 Delete a Network Management IP Address – Deletes one of the 3
IP address entries from the list of Network Management IP
Addresses.
 Delete All Network Management IP Addresses – Deletes all entries
from the list of Network Management IP Addresses.
 SNMP Traps – This submenu enables configuring SNMP Traps
sending parameters. It includes the following options:
 Traps Control - Enables/disables transmission of SNMP traps;
 Send SNMP Traps – Enables/disables sending of SNMP
traps. Available options are:
 Enable Traps Sending - enables sending of SNMP Traps.
The Traps that will be sent can be defined by the Per
Trap Control menu. The addresses to which these traps
will be sent and the SNMP Communities associated with
these Traps are defined by the SNMP Traps IP
Destination and the SNMP Traps Community options.
 Disable Traps Sending - no SNMP Traps will be sent by
the unit.
The default selection is Disable Traps Sending.
 Per Trap Control - When SNMP Traps Sending is enabled,
this menu allows defining for each individual Trap whether it
will be transmitted or not. The Traps that can be controlled
and the default option for each Trap are detailed in
Table 2-14.
NOTE:
In the GU only the Disable and Activate Management IP Filtering on Ethernet
Port options are available.