Instruction manual

2-66
BreezeACCESS Version 4.3 Operations and Administration
Manual Revision: 4.0
The default selection is Disable.
Network Management Parameters
(AU, SU and GU)
This feature allows protecting the unit from trials of unauthorized
access by defining a set of IP addresses from which management of the
unit (Telnet, TFTP, SNMP, ICMP) is allowed (excluding transmission of
messages generated in the unit such as Traps or Ping Test frames). This
feature also supports the possibility of defining the direction (from the
wireless media or from the wired Ethernet or from both) from which
such access is allowed. In addition, this menu enables configuring
SNMP Traps sending parameters. The Network Management Parameters
menu includes the following options:
 Access to Network Management – Defines the port through which
the unit can be managed. The options are the following:
 From Wlan Only
 From Ethernet Only
 From Both Ethernet & WLAN
The default selection is From Both Ethernet & Wlan.
 Network Management Filtering – Enables/disables management
filtering. If management filtering is enabled, the unit can only be
managed by stations whose IP addresses match one of the entries in
the Set Network Management IP Addresses (see next parameter)
that are connected to the unit via the defined port(s). Available
options are:
 Disable – No IP address based filtering
 Activate Management IP Filter On Ethernet Port – Applicable
only if the Access to Network Management parameter is
configured to either From Ethernet Only or From Both
Ethernet & Wireless Link. The unit can be managed from the
Ethernet port only by stations whose IP addresses match one of
the entries in the Set Network Management IP Addresses list. If
the Access to Network Management parameter is configured
to From Both Ethernet & Wireless Link, than there is no IP
address based filtering on the wireless port.
 Activate Management IP Filter On Wlan Port – Applicable only
if the Access to Network Management parameter is configured
to either From Wireless Link Only or From Both Ethernet &
Wireless Link. The unit can be managed from the wireless link
port only by stations whose IP addresses match one of the
NOTE:
The Access to Network Management option is not available in the GU, as this module
does not have a wireless link interface.