Instruction manual

2-64
BreezeACCESS Version 4.3 Operations and Administration
Manual Revision: 4.0
this parameter is not applicable and instead the Maximum
Voice Sessions parameter (see page 2-63) is used. The value of
the ACSE Maximum Voice Sessions parameter specifies the
maximum number of simultaneous ACSE voice sessions that
can be conducted by the SUs associated with this AU. If the
number of active voice sessions reaches this number, any
additional SU trying to initiate a voice session will not get a dial
tone. As this value increases, voice quality may deteriorate as
more users share the same bandwidth for voice sessions.
The selection range is from 0 to 21.
The default value is 21.
 ACSE Number Of Retransmissions For Data – The maximum
number of times that a data packet that was not acknowledged
will be retransmitted. When the ACSE Option is enabled, this
parameter overrides the Number Of Retransmissions
parameter (see page 2-82). This parameter has no effect when
the ACSE Option is disabled. This parameter is applicable to all
units in deployment where the ACSE Option is enabled,
including units that do not support voice, since they are also
affected by the use of the ACSE protocol.
Valid values are from 0 (no retransmissions) to 100.
The default value is 6.
 ACSE Number Of Retransmissions For Voice (AU and SU with
voice support) – The maximum number of times that a voice
packet that was not acknowledged will be retransmitted. When
the ACSE Option is enabled, this parameter overrides the
Number Of Retransmissions parameter. This parameter has no
effect when the ACSE Option is disabled.
Valid values are from 0 (no retransmissions) to 100.
The default value is 30.
 Show ACSE Parameters – Displays the current settings of all
ACSE parameters. The display in the SU includes the ACSE
Option, which is only configurable in the AU. It also includes
the ACSE Dwell Time, which is set to 60 milliseconds.
 Scanning Mode (SU only) – Defines whether to use Active or
Passive scanning. In active scanning, the SU transmits a Probe
Request upon power-up. In passive scanning, the SU searches for a
Beacon message from an AU prior to starting the
authentication/association process. This parameter is not
applicable if the ACSE Option is enabled, in which case passive
scanning is always used.
NOTE:
A voice session is defined as a voice connection between an SU and an AU.
A session between two SUs that are served by the same AU is counted as two
voice sessions.