Instruction manual

2-58
BreezeACCESS Version 4.3 Operations and Administration
Manual Revision: 4.0
c. If the SU is associated with the AU but there are too many
successive dropped frames, indicating that it transmits at a
level that may be too low.
The actual run-time value that is used to control the transmit power
level is determined by the ATPC process.
The allowed range is from 0 to 7.
The effect of the Power Control Parameter on the actual power
transmitted to the antenna port of the outdoor unit is according to
Table 2-11 (5.7 GHz series) or Table 2-12 (5.2 GHz series).
Table 2-11: Transmit Power Output vs. Transmit Power Control (5.7 GHz series)
Table 2-12: Transmit Power Output vs. Transmit Power Control (5.2 GHz series)
The default value is 7 (maximum power). -
 ATPC Parameters in AU
Transmit Power Control Transmit Power at Antenna Port (dBm)
7 26 +/- 1
6 25.5 +/ 1.5
5 23 +/- 1.5
4 20 +/- 1.5
3 20.5 +/- 1.5
2 17 +/- 1.5
1 12 +/- 1.5
0 8.5 +/- 1.5
Transmit Power Control Transmit Power at Antenna Port (dBm)
7 25dBm +/- 1dB
6 24dBm +/- 1dB
5 21dBm +/- 1.5dB
4 18dBm +/- 1.5dB
3 16.5dBm +/- 1dB
2 12.5dBm +/- 1.5dB
1 8.5dBm +/- 1.5dB
0 5dBm +/- 1.5dB
NOTE:
It is recommended not to change the Transmit Power Control parameter from its
default value in units with HW revision G or earlier.