Instruction manual

Menus and Parameters
2-37
BreezeACCESS Version 4.3 System Manual
 DHCP Client
 DHCP Options – Displays the current status of the DHCP
(Dynamic Host Configuration Protocol) support, and allows
selecting a new operation mode. The available options are:
 Disable – Use manual procedure for configuring the IP
parameters.
 DHCP Only – Search for a DHCP Server and obtain the IP
parameters from it (IP Address, Subnet Mask and Default
Gateway Address).
 Automatic – Search for a DHCP Server for configuration of
the IP parameters. If a DHCP Server is not found within
approximately 40 seconds, use the currently configured IP
parameters.
The default is Disable.
 Access to DHCP – To define the port through which the unit is
allowed to communicate with a DHCP server. The options are:
 From Wlan Only
 From Ethernet Only
 From Both Ethernet & WLAN
The default for an Access Unit is From Ethernet Only. The
default for a Subscriber Unit is From Wlan Only.
 Show IP Parameters – Displays the current values of the IP
Parameters.
Air Interface Parameters (AU and
SU)
Hopping Frequencies Setting Parameters
The process of setting the hopping sequence includes the following
steps:
a. Select the frequencies to be used
b. Define the method of generating the basic hopping sequence
based on the set of selected frequencies. The method of
generating the basic sequence also defines the hopping shift
mechanism for generating different actual hopping sequences.
c. Define a different hopping sequence for each AU in order to
minimize interference between adjacent AUs.
NOTE:
The Access to DHCP option is not available in the GU, as this module does
not have a wireless link interface.