Instruction manual

Menus and Parameters
2-5
BreezeACCESS Version 4.3 System Manual
The following parameter appears for GPS Modules only:
 Unit Status – Indicates the status of the GPS antenna. Either one of
the following messages may be displayed:
 UTC is available; date..; time..: This message indicates
that the GPS antenna has synchronized with the satellite system
and that the BS-GU is functioning properly. The message may
include an incorrect time and date, such as a date in 1999. This
indicates that the GPS antenna has not yet synchronized with
the GPS satellites system.
–Or–
 UTC time is not available: This message indicates that the
BS-GU is not getting timing signals from the GPS antenna. If the
antenna is functioning and properly connected to the module,
this may be because the antenna has not yet synchronized with
the GPS satellite system.
Show Basic Parameters
The Show Basic Parameters menu displays the current values of the
parameters included in the Basic Configuration menu
(see Basic Configuration Menu
‚ page 2-13). When using Read-Only
access rights the ESSID parameters (ESSID, Operator ESSID, Run Time
ESSID and Neighboring AU ESSID) and WEP Keys are not displayed.
The display includes some additional useful read-only information such
as the Number of Hopping Frequencies in SU and AU.
Show Advanced Parameters
The Show Advanced Parameters menu enables access sub-menus that
display the current values of the parameters included in the applicable
sub-menus of the Advanced Configuration menu
(see Advanced Configuration Menu
‚ page 2-36). When using Read-Only
access rights the ESSID parameters (ESSID, Operator ESSID, Run Time
ESSID and Neighboring AU ESSID in Air Interface Parameters), WEP
Keys (Security Parameters) and User Password and Shared Secret
(RADIUS Parameters) are not displayed. The display includes some
additional read-only information such as Number of Hopping
Frequencies (Air Interface Parameters).
Show All Parameters
The Show All Parameters menu displays the current values of all the
parameters included in the Advanced Configuration menu.When using
Read-Only access rights the ESSID parameters (ESSID, Operator
ESSID, Run Time ESSID and Neighboring AU ESSID in Air Interface
Parameters), WEP Keys (Security Parameters) and User Password and
Shared Secret (RADIUS Parameters) are not displayed. The display