Instruction manual

Accessing the Monitor Program
1-3
BreezeACCESS Version 4.3 System Manual
Accessing the Monitor
Program using Telnet
1. Connect a PC to the Ethernet port of the unit. See the table below to
determine the type of cable. Configure the PC’s IP parameters to enable
connectivity with the unit (the default IP Address is 10.0.0.1). Run the Telnet
application.
Table 1-2: Required Type of Ethernet Cable
2. The Select Access Level menu appears. Select the access level according to
your authorized access level. You will be requested to enter your password.
After entering the correct password press Enter.
The Main Menu appears.
Figure 1-1: Main Menu – Administrator Access Rights (SU and AU)
 The appearance of the Main Menu varies in accordance with the set
access level.For users with Read Only access rights, only the Info
Screens option is displayed. Users with this access level cannot
access the Unit Control, Basic Configuration, Site Survey and
Advanced Configuration menus.
Unit Type
Connection to a
PC
Connection to a
Hub
Subscriber Units Straight Crossed
Access Units Crossed Straight
GPS module Straight Crossed
BreezeACCESS/AU-BS
Official Release Version – 4.0.40
Release Date: Thu Dec 20 20:21:36 2001
Main Menu
=====================
1 – Info Screens
2 – Unit Control
3 – Basic Configuration
4 – Site Survey
5 – Advanced Configuration
X - Exit
>>>