User`s guide

BreezeNET DS.11 Series User’s Guide
3-24
♦ Preferred BU (RB only) Parameters: When the Enforce option is enabled, the
RB will associate only with the BU whose MAC address is defined in the MAC
Address edit box. The default for the Enforce option is Disable. The default
Preferred BU MAC Address is 00-00-00-00-00-00 (none). If the Preferred BU
MAC Address is the default one (none), then the Enforce option has no effect
and unit will operate normally –it will either use the Best BU Selection
algorithm (if enabled), or try to associate with the first BU it finds (if the Best
BU Selection algorithm is disabled).
♦ Best BU Selection (RB only): When enabled, the RB performs a scanning cycle
measuring the strength of the signal received from all BUs it finds. If the RB
can connect to more than one BU, it will connect to the BU with the strongest
signal. The default is Disable.
♦ Bridge Aging Time (BU only): Defines the time that an RB can remain non-
active without being removed from the bridging table. If for the defined time
there was no traffic to/from the RB, it will be de-authenticated. The range is
from 10 to 1,000,000 seconds. The default value is 1800 seconds.
Auto-Config Tab
The Auto-Config tab enables quick configuration of various modes by setting
predefined values for several parameters upon clicking the applicable button.
Figure 3-15: Auto-Config Tab
♦ Set PtP Mode: Click to set the following parameters to support optimized
configuration for Point-to-Point operation:
 Minimum Contention Window = 15
 RTS Threshold = 2437