Instruction manual
Setting Basic Parameters
1-5
BreezeACCESS Version 4.5 System Manual
Configuring Basic Parameters
in Access and Subscriber
Units
The maximum output power for compliance with the applicable IC&FCC
regulations are listed below.
Table 1-3: Maximum Output Power for FCC Compliance
The Basic Configuration menu in the Monitor program includes all the
parameters necessary for the initial operation of BreezeACCESS
Subscriber and Access Units. In many installations, most of these
parameters should not be changed from their default values. The
following list includes the basic parameters and their default values:
WARNING:
For compliance with IC&FCC regulations, AU, SU-I and SU-A units (SU-R not certified
for HDM) in HDM mode must be configured to ensure that the output power does not
exceed 19 dBm. In legacy units that were upgraded from firmware version 4.3 or lower,
it is mandatory to attach the new IC&FCC HDM ID label to the unit. Note that the HDM
label is only available from Alvarion when ordering Firmware 4.5.Upgrade Kit.
Mode of Operation
Max Power
Output
IC&FCC ID Label
FH (Non HDM) 26 dBm FH Model
HDM 19 dBm FH Model & *HDM Model
* IC 2514A-IF24SYNC FCC ID LKT-IF-24-SYNC
Table 1-4: Subscriber and Access Units Basic Parameters
Parameter Default Value Comment
IP Address 10.0.0.1
Subnet Mask 255.0.0.0
Default Gateway Address 0.0.0.0
DHCP Option Disable
Access to DHCP AU: From Ethernet Only
SU: From WLAN Only
Hopping Set (AU) 1 Not applicable if HDM Mode is
enabled
Hopping Sequence (Shift) (AU) 1 (0 if HDM Mode is enabled)
HDM Mode Disable Applicable only to FCC hopping
standards
Flexible Hopping Definition FCC: 2402 Applicable only if HDM Mode
is enabled