Instruction manual

3-12
BreezeACCESS Version 4.5 Installation
Manual Revision 1.0
1. Plug the output jack of the power transformer into the DC input jack (marked
DC IN 5V) located on the side of the unit.
2. Connect the power transformer to a power outlet - 110/ 220VAC.
3. Use an Ethernet 10BaseT cable to connect a PC or a hub to the Ethernet port
located on the rear panel of the unit. See Table 3-1‚ page 3-3 for details on
the required type of the Ethernet cable.
4. For Subscriber Units that support voice, use the telephone cord to connect
the telephone port, located on the rear panel of the unit, to the user’s
telephone set.