Instruction manual

Indoor SU-I and AU-I Units
3-11
BreezeACCESS Version 4.5 System Manual
Connecting Antenna(s) to the Units
For installation convenience, a torque key is included with all
BreezeACCESS SU-ID and AU-ID units.
Use the included torque key to tighten the cable(s) to the connector(s)
on the side of the unit. The key is designed to prevent over tightening of
the screws and protects the connectors from damage.
Tighten the cable(s) to the connector(s) using the torque key.
Figure 3-7: Tightening the Cable(s) to the Connector(s)
If excessive pressure is applied to tighten the screws, the torque key will
break.
Connecting the Unit to the Power
Supply and to the CPE
The unit operates on a power input of 5VDC, supplied by the power
transformer included with the unit.
WARNING:
The use of improper tools for tightening antenna connection cables to BreezeACCESS
units may result in damage to the cable connectors.
NOTE:
Do not attempt to tighten the screws any further. This may damage the connectors on
the BreezeACCESS unit.