Instruction manual

3-10
BreezeACCESS Version 4.5 Installation
Manual Revision 1.0
Wall Mounting the Unit
Use the supplied brackets for wall mounting to install the unit on a wall
or a ceiling.
1. Turn the unit so the rear panel is facing you.
2. Unscrew the two screws located at the antennas end of the unit (the top
screws).
3. Align the Unit Mounting Slots (see Figure 3-6) with the slots you have just
unscrewed.
4. Using the longer screws supplied with the wall mounts, screw the wall
mount to the unit.
5. Align the Convenience Mounting Slots (see Figure 3-2) with the nails, push
the wall mount against the wall and let it slide down until it rests on the
nails.
Figure 3-5: Wall Mounting the Unit
Special slots have been added to the wall mounts to allow for
unobtrusive cable installation. These slots should be used to fasten
cables coming out of the unit to the wall mounts, eliminating loose or
tangled cable installations.
Figure 3-6: Wall Mounting Plate
Convenience Mounting Slots
Unit Mounting Slots
Cable Fastening Slots