Instruction manual

IF Based Equipment
1-9
BreezeACCESS Version 4.5 System Manual
Pole Mounting the Outdoor Unit
The outdoor unit can be secured to the pole using one of the following
options:
! Special brackets and open-ended bolts (supplied with each unit).
There are two pairs of threaded holes on the back of the unit,
allowing use of the special brackets with various pole widths.
! Metal bands (9/16" wide, minimum 12" long).
Figure 1-3‚ page 1-10
shows the locations of the band grooves and
threaded holes on the rear side of the outdoor unit.
Figure 1-4‚ page 1-10
illustrates the method of installing an outdoor
unit on a pole, using the brackets and open-ended bolts.
NOTE:
Make sure to install the unit with the bottom panel (the panel with the IF connector)
facing downward.