Instruction manual

Menus and Parameters
2-115
BreezeACCESS Version 4.5 System Manual
" Ring DC Component - The DC component of the ring signal.
The available options are 0 volts and –30 Volts.
Default: country specific.
" Ring Amplitude - The amplitude of the ring signal.
The available range is from 30 to 60 Vrms.
Default: country specific.
" Ringer Cadence/Pattern - The ring pattern Includes the
following parameters:
# Ring Cadence On 1
# Ring Cadence Off 1
# Ring Cadence On 2
# Ring Cadence Off 2
# Ring Cadence On 3
# Ring Cadence Off 3
The range for each of the Cadence On/Off parameters is from 0
to 8000 milliseconds.
Default: country specific.
" Ring Duration - The maximum ring duration.
The available range is from 0 to 1000 seconds.
Default: country specific.
" Measure REN Load – Displays the last results of the REN Load
Measurement test and enables to initiate a REN Load
Measurement test.
Note: The REN test is an interruptive test.
! Wizard – The Wizard option helps to properly configure the Line
and Ring parameters through a step-by-step process. It guides the
user through each step, displaying the available options for the
current parameter, taking into account the previously configured
parameters and electrical restrictions.
Special Features
The Special Features menu includes the following parameters:
! Caller ID: - Defines whether the unit supports generation of Caller
ID (CID) signaling, and if CID generation is supported, which
standard will be used. The unit supports two CID signaling
standards:
" Voice band Frequency Shift Keying (FSK) signaling in
accordance with ETSI ETS 300 659 – 1
" 1200-baud tone modulation in accordance with Bellcore 202
standard.
The Caller ID parameter is supported only by units using a Voice
card HW revision D and higher.