Instruction manual

Menus and Parameters
2-109
BreezeACCESS Version 4.5 System Manual
Default selection is Disable.
" Inter-Regional Prefix – Defines the prefix indicating an
inter-regional call. This is also the first digit in the two digits
string indicating an international call.
Valid values: One phone key-pad digit (0-9, *, #, A, B, C, D) and
X (no prefix).
Default value: 0.
" International Prefix – Defines the second digit in the two digits
string indicating an international call.
Valid values: One phone key-pad digit (0-9, *, #, A, B, C, D) and
X (no prefix).
Default value: 0
! Overlap Sending - To enable or disable the overlap sending feature.
A gatekeeper or a gateway supporting overlap sending does not
require dialing termination signaling for setting up a call. Otherwise
a dialing termination signal must be supplied by the unit.
When Overlap Sending is enabled, each dialed digit is transmitted
immediately. When disabled, dialed digits are accumulated and
transmitted according to the rules set by other dialing parameters.
Upon enabling overlap sending, the settings of other dialing
parameters are overridden as follows:
a. IP Dialing Option, Dialing Prefix Option and Stop Dialing
Indicator are disabled even if the applicable parameter is set to
Enable.
b. Automatic Prefix is not used and Stop Dialing Timeout has
no effect.
The default selection is Disable.
! Empty Setup Option - To enable or disable the empty setup
feature. When enabled, the unit sends a setup message to the
gateway upon identifying the off-hook status, without waiting for
completion of dialing. An H.323 session with the gateway is being
established, and the gateway is responsible for managing the call.
The default selection is Disable.
! Empty Setup Number- The telephone number to be used in an
Empty Setup Message. If the string is empty the Empty Setup
Message is sent without any telephone number.
! T.38 Channels In Fast Start – To enable or disable the
transmission of T.38 channel information (IP ports, etc.) in the
setup message as a part of the fast start information. The default is
to send this information. With some third party GK/GW this
information may cause problems in the T.38 interoperability, so
transmission in the Fast Start can be disabled. In those cases the
needed information will be sent at later stage once a T.38 session
starts.