Instruction manual

2-72
BreezeACCESS Version 4.5 Operations and Administration
Manual Revision: 1.0
! Enable Traps Sending - enables sending of SNMP Traps.
The Traps that will be sent can be defined by the Per
Trap Control menu. The addresses to which these traps
will be sent and the SNMP Communities associated with
these Traps are defined by the SNMP Traps IP
Destination and the SNMP Traps Community options.
! Disable Traps Sending - no SNMP Traps will be sent by
the unit.
The default selection is Disable Traps Sending.
# Per Trap Control - When SNMP Traps Sending is enabled,
this menu allows defining for each individual Trap whether it
will be transmitted or not. The Traps that can be controlled
and the default option for each Trap are detailed in
Table 2-12.
Table 2-12: Per Trap Control
" SNMP Traps IP Destination – Displays the current values of 3
IP addresses that are defined as the trap destinations. Allows
entering a new address for each of the 3 entries.
Trap Unit Default
Send SU Associated AU Trap AU Enable Trap Sending
Send Disassociated Trap AU Enable Trap Sending
Send AU Aging Trap AU Enable Trap Sending
Send AU Wireless Quality Trap AU Enable Trap Sending
Send SU Associated Trap SU Enable Trap Sending
Send SU Wireless Quality Trap SU Enable Trap Sending
Send Parameter Changed Trap AU, SU Enable Trap Sending
Send GPS Alarm In Trap GU Enable Trap Sending
Send GPS Alarm Out Trap GU Enable Trap Sending
Send UTC Status Trap GU Enable Trap Sending
Send Power Up From Reset Trap All AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Send Monitor Status Trap All Enable Trap Sending
Send Cold \ Warm Start Trap All AU, GU: Enable Trap Sending
SU: Disable Trap Sending
Send AU Loss Of Sync Trap BS-AU in slave mode Enable Trap Sending
Send AU Alarms Traps IF-based AU Enable Traps Sending
(applicable to all AU Alarms
Traps)
Send Ethernet Broadcast Limiter
Trap
AU, SU Disable Trap Sending