Instruction manual

2-68
BreezeACCESS Version 4.5 Operations and Administration
Manual Revision: 1.0
including units that do not support voice, since they are also
affected by the use of the ACSE protocol.
Valid values are from 0 (no retransmissions) to 100.
The default value is 6.
" ACSE Number Of Retransmissions For Voice (AU and SU with
voice support) – The maximum number of times that a voice
packet that was not acknowledged will be retransmitted. When
the ACSE Option is enabled, this parameter overrides the
Number Of Retransmissions parameter. This parameter has no
effect when the ACSE Option is disabled.
Valid values are from 0 (no retransmissions) to 100.
The default value is 30.
" Show ACSE Parameters – Displays the current settings of all
ACSE parameters. The display in the SU includes the ACSE
Option, which is only configurable in the AU. It also includes
the ACSE Dwell Time, which is set to 60 milliseconds.
! Scanning Mode (SU only) – Defines whether to use Active or
Passive scanning. In active scanning, the SU transmits a Probe
Request upon power-up. In passive scanning, the SU searches for a
Beacon message from an AU prior to starting the
authentication/association process. This parameter is not
applicable if the ACSE Option is enabled, in which case passive
scanning is always used.
The default is Active
! MAC Address Black List (AU only) - Enables to define units that are
not authorized to receive services. The AU will not provide services
to a unit whose MAC Address is included in the black list. This
feature enables to disconnect units from the services in cases such
as when the user had fraudulently succeeded to configure the unit
to values different than his subscription plan. The black list can
include up to 100 MAC Addresses.
" Add MAC Address to Black List - To add a MAC Address to the
Black List.
" Remove MAC Address from Black List - To remove a MAC
Address from the Black List.
" Show MAC Address Black List - To display the current list of
MAC Addresses included in the black list.
NOTE:
When Best AU support is enabled, it is recommended to use Active Scanning.
If passive scanning is used, the SU may not hear the best AU (or the preferred
AU). The higher the number of hopping channels, the higher the probability
that the SU will not hear the best (or preferred) AU when passive scanning is
used.