Instruction manual

2-14
BreezeACCESS Version 4.5 Operations and Administration
Manual Revision: 1.0
Basic Configuration Menu
The Basic Configuration menu includes all the parameters that are
necessary for the initial installation and operation of the unit. Once the
unit is properly installed and operational, other parameters can be
configured either locally using the monitor program or remotely using
Telnet, SNMP management or TFTP for loading to the unit a
pre-prepared configuration file.
For more information about the initial configuration of BreezeACCESS
units, see Book 3: Commissioning.
The Basic Configuration menu includes the following submenu
parameters:
IP Parameters
! IP Address (see page 2-37)
! Subnet Mask (see page 2-37
)
! Default Gateway Address (see page 2-37
)
! DHCP Client (see page 2-38
)
Air Interface Parameters
! ESSID (see page 2-53)
! Operator ESSID Parameters (AU) (see page 2-54
)
! Hopping Sequence (Shift) (see page 2-39
)
! Hopping Set (see page 2-39
)
! Hopping Sync (AU-BS) (see page 2-53
)
! Hybrid Digital Modulation (HDM) see page 2-40
! Transmit Antenna (SU-R, SU-I/I-D) (see page 2-65)
! Transmit Power Control (IF-based units) (see page 2-58
)
! ATPC Option (IF-based units) (see page 2-62
)
! Receive Attenuation Control (IF-based SU) (see page 2-65
)
! Power Level (SU-R and SU-I/AU-I only) (see page 2-60
)
! Best AU Parameters (SU) (see page 2-55
)
" Best AU Support
" Preferred AU MAC Address
! Maximum Data Rate (SU) (see page 2-62
)
! Scanning Mode (SU) (see page 2-67
)