Instruction manual

1-6
BreezeACCESS Version 4.5 Commissioning
Manual Revision: 1.0
Scrambling Mode Enhanced Applicable only if HDM Mode
is enabled
Manual Sequence Definition Applicable only when
Srambling Mode is configured
to Manual Scrambling
Spanning Factor 1 Applicable only for Enhanced
Scrambling with 7 or more
frequencies
Hopping Sync
(AU-BS only)
Idle 1. Cannot be changed in units
configured to country standard
US FCC, Canada and Australia.
2. If synchronization without
GPS is to be supported, one AU
should be configured to Master,
all other AUs should be
configured to Slave.
3. When GPS is used for
synchronization, all AUs should
be configured to Slave.
Transmit Antenna
(SU-R, SU-I/AU-I)
Antenna 1
Transmit Power Control
(IF-based units)
15 For compliance with FCC
requirements, the output power
when operating in HDM Mode
should not exceed 19 dBm.
Power Level
(SU-R, SU-I/AU-I with HW
revision C or lower)
High Cannot be changed in units
configured in the factory to
“Low” for compliance with local
regulations.
Transmit Level (SU-I/AU-I
with HW revision D or higher)
17 For compliance with FCC
requirements, the output power
when operating in HDM Mode
should not exceed 19 dBm.
ATPC Option
(IF-based units)
AU Disable
SU: Enable
Receive Attenuation Control
(IF-based SU)
0
Scanning Mode (SU) Active
ESSID ESSID1
Operator ESSID Option (AU) Enable
Operator ESSID (AU) ESSID1
Best AU Support (SU) Disable
Preferred AU MAC Address
(SU)
00-00-00-00-00-00 (none) Applicable only when Best AU
Support is enabled
VLAN Link Type Hybrid Link
VLAN ID – Management 65535
Table 1-4: Subscriber and Access Units Basic Parameters
Parameter Default Value Comment