User manual

Chapter 2 - Managing a Single Device/Cell Air Interface Country Code Parameters Page
AlvariCRAFT Device Manager 69 User Manual
The read-only Sub Bands Table displays the following details for each of the Sub
Bands supported by the Country Code:
Authentication
Encryption Support
Read-only indication of whether encryption of authentication
messages is supported by the applicable Country Code
Sub Band Select Where more than one Sub Band (bandwidth) is available, this option
enables selection of the Sub Band to be used by AU/BU.
For SU/RB, this option defines the Sub Band to be used during
Spectrum Analysis.
Country Code Learning
By SU
Applicable only for AU. This feature support simplified installation and
updates processes by enabling the SU to adapt the Country Code
used by the AU.
The AU advertises its country code in every beacon and association
response message. Upon synchronization the SU will check if its
country code and the country code received from the AU are the
same. If they are not the same and the Country Code Learning By SU
is enabled, the SU will use the AU's country code and the country
code derived limitations will be forced.
The SU will learn a new Country Code only if it is running from the
Main version. After country code learning (adaptation) the unit is
automatically reset.
Country Code Select This option enables changing the Country Code used by the unit. In
the current release this option is applicable only to units in the 5.4 and
5.8 GHz bands.
The default Country Code is set in factory according to the destination
country.
CAUTION: The selected Country Code must comply with applicable
local radio regulations.
Sub Band ID The Sub Band ID (number).
Frequencies (MHz) The frequencies supported by the Sub Band.
Bandwidth (MHz) The Bandwidth supported by the Sub Band.
Max Tx Power (dBm) The maximum transmit power allowed at the antenna port of the unit.
Max EIRP (dBm) The maximum allowed EIRP (Effective Isotropic Radiated Power) in
dBm, or No Limit.
Min Mod. Level The lowest allowed modulation level.
Max Mod. Level The highest allowed modulation level.
Burst Mode Indication of whether Burst Mode operation is allowed.