User manual

Chapter 2 - Managing a Single Device/Cell Air Interface Country Code Parameters Page
AlvariCRAFT Device Manager 68 User Manual
2.8 Air Interface Country Code Parameters
Page
Each country has its own regulations regarding operation modes and parameters
such as allowable frequencies and bandwidth, the need to employ a certain
mechanism (DFS) for automatic detection and avoidance of frequencies used by
radar systems, limits on maximum transmit power and/or EIRP at each of the
supported modulation levels, and the ability to use burst transmissions. To
efficiently manage these country dependent parameters, each unit is supplied
with a pre-configured Country Code that includes a set of parameters, which
depend on this country code. Where more than one set of parameters can be used,
the available sets are defined as Sub-Bands.
* The Country Code Learning By SU parameter is not available in the Country
Code Parameters pages for SU, BU and RB.
The Air Interface Country Code Parameters page includes the following
parameters:
Figure 2-18: Air Interface Country Code Parameters Page - AU*
Country Code The read-only name of the Country Code.
Data Encryption Support Read-only indication of whether data encryption is supported by the
applicable Country Code.
AES Encryption Support Read-only indication of whether AES-based encryption is supported
by the applicable Country Code