User manual

Chapter 2 - Managing a Single Device/Cell Air Interface Interference Mitigation Parameters Page
AlvariCRAFT Device Manager 65 User Manual
2.7.1 Basic Parameters
The Basic Parameters section is used for collecting the primary input required for
the analysis process.
Installation Model Defines the type of topography for the sector:
 LOS - For Line Of Sight setups
 nLOS - For Near Line Of Sight setups
 NoLOS - For No Line OF Sight setups
Requestet Throughput The minimum value (in Kbps) for the achievable throughput when
optimizing distance. When the Best Channel Selection optimization
mechanism is set to Best Throughput, this parameter is ignored.
Range: 500 - 6000 Kbps
Requested Maximum
Distance
The minimum value (in meters) for the achievable distance when
optimizing performance. When the Best Channel Selection
optimization mechanism is set to Best Distance, this parameter is
ignored.
Range: 500 to 54000 m
Best Channel Selection The optimization mechanism employed when performing Interference
Mitigation:
 Best Throughput (while preserving the Requested Maximum
Distance)
 Best Distance (while preserving the Requested Throughput)
Scanning Type The output that the Interference Mitigation process will provide:
 Clear Channel & Automatic Noise Floor Selection - for optimizing
both the operating channel and noise floor level
 Automatic Noise Floor Selection Only - for optimizing only the
noise floor level
 Clear Channel Selection Only - for optimizing only the operating
channel
 Statistics Only - for performing only a spectrum analysis, without
suggesting any operating channel and noise floor level