User manual

Chapter 2 - Managing a Single Device/Cell Air Interface Frequency Page
AlvariCRAFT Device Manager 51 User Manual
Check the Clear Detection Status After Reset check-box to set all Detection
Status entries to Radar Free after the next reset of the unit.
2.4.3 Planned Frequency Definition Table
For an AU/BU, this table is available only in units using a Country Code that
supports DFS. It enables defining the frequencies that will be used in the DFS
mechanism when enabled. It includes all the frequencies of the selected
Sub-Band.
For an SU/RB, this table enables defining for each of the available Sub-Bands the
frequencies that will be used by the SU/RB when scanning for an AU/BU. For
each available Sub-Band, all the available frequencies and the radar detection
status are displayed.
Each entry in the table includes the following parameters:
On SU/RB you can check the Clear Detection Status After Reset check-box to
set all Detection Status entries to Radar Free after the next reset of the unit.
Click on the Exclude All button to exclude all entries from the list (set all Include
values to No).
Click on the Include All button to include all entries in the list (set all Include
values to Yes).
Detection Status The status of the frequency in the device’s database: Radar Free,
Radar Detected or Adjacent to Radar.
Sub Band Applicable only for SU and RB. The read-only number of the Sub
Band.
Bandwidth (MHz) Applicable only for SU and RB. The read-only bandwidth used by the
Sub Band.
Frequency (MHz) The read-only frequency
Include Indicates whether the entry should be included in the list of
frequencies to be used. To change, double-click on the entry: A
dropdown menu opens, allowing selection between Yes (include) and
No (exclude).
Detection Status Applicable only for SU and RB. The status of the frequency in the
device’s database: Radar Free, Radar Detected or Adjacent to Radar.