User manual

Chapter 2 - Managing a Single Device/Cell Multiple Configuration SU-L Page
AlvariCRAFT Device Manager 193 User Manual
Check the Reset checkmark to reset the units. After reset, the units will run from
their main SW version. All changes to parameters that require reset that were
done prior to the reset operation are applied.
The LED Operation Mode option controls the SNR bar and LED indicators’
behavior. By default, the LEDs indicate the SNR level, which facilitates SUs
antennas’ alignment. However, the SNR bar can be customized to indicate when
specific thresholds for RSSI, SNR, CRC percentage and average modulation are
reached. You can switch between two operation modes:
 Normal: This is the default operation mode. The green LEDs on the bar
indicate the SNR level while the LED indicators show the unit’s status,
ethernet and wireless activity.
Figure 2-77: Multiple Configuration Page SU-L - Unit Control